I am loving this version with my new Maddog, but am running into a problem. I make through successful push back and engine start, but there is no response to my "After Engine Start Check" command. The correct words appear on the green line, but no check list and no way that I can find to continue. This is my first voice command version. This is likely some operator error. The one deviation I use that I have used without problem with former versions in other aircraft is that I set up for 30 minutes, but always finish my setup a little early and fast forward (slowly) to about five minutes. Is it likely that this is creating the problem or something else? Thank you.Craig

I am loving this version with my new Maddog, but am running into a problem. I make through successful push back and engine start, but there is no response to my "After Engine Start Check" command. The correct words appear on the green line, but no check list and no way that I can find to continue. This is my first voice command version. This is likely some operator error. The one deviation I use that I have used without problem with former versions in other aircraft is that I set up for 30 minutes, but always finish my setup a little early and fast forward (slowly) to about five minutes. Is it likely that this is creating the problem or something else? Thank you.Craig

Hi Craig,What 'mode' are you in as displayed in the FS2Crew Main Panel display.I suspect you're in the wrong mode.Mode should automatically cycle forward for you assuming you're following the correct procedure.Please take a second look at the manual.Best,