August 10, 201114 yr My NGX installation runs great while inside the cockpit however the outside view shows only a few elements of the aircraft where most of the fuselage is missing. What can I do to remedy? Brad Rich
August 10, 201114 yr sounds like you are using EZDOK? Had the same problem in the beginning as outside view is with VC camera and not the worldcamera. You have forgot to run the program that came with EZDOK after you have installed NGX :-).Easy solution run the manager program again. /Michael Michael Moe
August 10, 201114 yr This sounds like the old problem which was solved by Bojote a while back.If so, check that you have added HIGHMEMFIX=1 under the [Graphics] section of your fsx.cfg file. (NOTE there is a typing error in PMDG's "Introduction" at p12: the correct entry is "HIGHMEMFIX", NOT "HIMEMFIX"). Tim 14900ks, RTX4090, 64Gb@6000-30-36-36-T2, Samsung 990Pro 2Tb , Dell G3223Q 32" 4k Gsync + 27" secondary monitor. Thrustmaster Airbus Edition throttles etc, TPR pedals, MiniCockpit FCU, WinWings FCU, WinWings Orion 2 F15E, WinWings A320 sticks.
August 10, 201114 yr Author Michael is right. I am running ezdoc and forget to re-run a utility needed after new payware installs. Brad Rich
Create an account or sign in to comment