Hi. Does anybody know how to fix this? (please see pictures). I changed fsx.cfg file as instructed in Introduction to prevent a skeleton images but no luck. It was OK before I installed the latest hotfix.Thank you.

You have moved your eyepoint outside of the cockpit while in VC mode.If you use the EZDOK camera system, just rerun the config program and it should fix this.

You have moved your eyepoint outside of the cockpit while in VC mode. If you use the EZDOK camera system, just rerun the config program and it should fix this.

Thanks Jim.It looks as before now. And yes, I use EZDOK. If you are familiar with EZDOK can you help me if possible, no suggestions so far in EZDOK forum. I adjusted my cameras and now I cannot push or rotate any buttons on CA side. Everything is inhibited when I am on CA side, all other views are fine. It was the same problem with FO side but it fixed itself but now I have to deal with CA side. Can't figure out how to fix it. Also, before the latest hotfix I was able to adjust camera how I wanted it at any zoom level, now I see either headrest on both CA and FO sides or its shadow. I have to stay very close to MCP to avoid it. It is very annoying. I don't want to blame on a hotfix but it was not like that before.Thanks again.

I do have the program, but have temporarily disabled it until SP1 comes out, as I am very new to the software myself, and thought it best to wait until the NGX is fully stable at the Service Pack level before trying to learn the ins and outs of EZDOK and its interface to the NGX.Perhaps someone a bit better versed in EZDOK than I am can chime in here to answer some of your questions.