Hi guys...I'm having trouble wiht my -600 SAS.In the PMDG setup page, I've set the start up state to be "previous flight".However, every time I select my -600, it starts up not like I left it (I always shut down APU and all, and leave it on GND PWR).It allways start up with APU running and such - basically ready to do engine start (except the fuel pumps are not on).Same with the -700 SAS.I've tried to search here on the forum, but could not find an answer... I beleive this started after the SP1b - any ideas?Mas

I don´t do it in that way.If I wanna have my NGX in a specific way (always) when boarding it, I alwayshave saved the panelstate either in "C&D or Short turnaround, or Long Turnaround"Then you only have to start FSX and choose your NGX livery in Free Flight and the ac will be in that state,you have saved the panelstate in.You could even create a Panelstate yourself and save it and the ac will start up with that state always, whenstarting up FSX in the metodh I mentioned above./ Leffe

Hej Leif ;)Jamen problemet - hov - the problem is, that I like to leave the aircraft in different states from time to time - depeding on location and on how long the turn-around is. I used to be able to shut down the a/c the way I liked it (different from time to time), and then when I loaded it up for the next flight (hours later og maybe next day), it would start up as I left it... I'm always sure to end the flight correctly via the FS menu, and then shutting down FS...Antoher note to this is, that even though I configure the a/c as SAS operates it (like HUGS installed, No ETOPS and so on and so on) and also sets the standard TA for 5000 ft (and not 18000), starts up with default TA of 18000 in the PERF page and in the DES forecast page for TRL.Any ideas!?Mas