I test the e.g. ENG OVHT (800wl) and the bell sounds but I do not get a Master Caution indication (light).Anybody else see this?

With test switch is set to FIRE you get a FIRE WARNING (RED)

Andrea,Thank you.Does the bell ring for you?Do you have to "reset" the Master Caution to cancel it?

Check the button near the master caution, it has these words written: FIRE WARN BELL CUTOUTAll on the big red buttons on captain and FO sides.There is another bell cutout and it is on the fire panel (BELL CUTOUT)Just wonder on how to push both at the same time... Do you use key combination?

Andrea,When I move test switch to OVHT FIRE the bell rings.The Master Caution / Fire do not light.Is this correct? Nothing to reset?

No, they must light on, see it:The arrows are the cutout switches

Andrea,Yes, thank you for confirming.I do know the alarms from Level-D, iFly etc.I found the problem.I am using EZdok to change views /Throttle/Pedestal/FMC (starting from cold and dark checklist now).This, EZdok) causes the problems.If I make EZdok not active (keypad 3 key) and use the Hat Switch to move around the PMDG VC cockpit then the alarms and Master Caution function normally.

I also use ezdok with TIR and on my system is working fine.

Andrea,I have TrackIr but was not using it.I used EZdoc Throttle view.Fire test, bell rang/stopped when test switch released.EZdoc captains view.No master caution /fie lights.Odd!