Does the overtemperature work on your system guys? My bleed trip off only with overpressure.

Overtemp solo doesn't seem to work - loaded from a clean panel now. No trip off and no master caution. It also didn't trip any other failures after some time of flight.Jakub

I know I'm opening an ancient thread, but I just had this exact same thing happen.

 

Departed KLAS just a bit ago and was climbing to cruise. Got a master caution light and looked up to see the left bleed tripped off. I tried the reset button and followed the QRH as published. No luck. Currently flying on bleed 2 only. I'd read about if it was an over-pressure, you could switch on the EAI and then back off to relieve the pressure, but that also didn't work, so I'm assuming it was an overheat or something else completely.

 

I do have service based failures on and always use the short run panel state. Super excited to have my first failure  :lol:

Edited June 26, 201312 yr by FDX016 - Nick

Had this sort of thing a while ago.. check the service based failures.. 
Mine was on without me knowing it.