I just edited a panel by taking out VOR1 and replacing the DG with an HSI.

 

I'm using an RXP 430 in the panel.

 

However, I found that if VOR1 is installed, the HSI reacts to NAV1 normally, even if the 430 is turned off - but if VOR1 is removed, the HSI only links to the NAV freq. on the 43

 

Is there a way around this? I want to be able to use the NAV radios with the HSI when the 430 is off.

 

Also - is there a way to get the 430 to sync with the NAV stack?

 

Also #2, , I have a Saitek radio panel, and would like to be able to control the NAV freqs on the 430 with it, but not sure if this is possible. :)

 

Being pretty new at this I know what I want but not what I'm doing!

 

cheers

Andrew

I'm using an RXP 430 in the panel.

 

You might also consider browsing and maybe posting this on the (unofficial) RealityXP Support forum over at SimForums if you have not alreday done that.

 

http://www.simforums.com/forums/forum12.html

 

Rgds, Bob

Thanks!

 

Didn't even know it was there. That will be very helpful.

 

[edit] actually... I did. I must have registered a LONG time ago!

 

cheers