Hi all. ok i am having a problem setting up my Saitek cessna trim wheel i go to control setup everything is recognized Yoke Rudder Pedels and my trim wheel,

I set this in advance mode close the box reopen it and its reverted to simple mode this happens every time. any suggestions thanks . ken.

When you click to advance mode, you can set those parameters, are you saying that after you close the box the settings you just made in Advance Mode are reset or are you say that the control box just switches back to simple mode.

 

The question is if you click on advance mode again are the setting exactly as you had them set before closing the box, because if they are not resetting then they are still valid.

This is an automatic message.

 

This topic has been moved from "MS FSX Forum" to "Hardware Controllers & Drivers". This move has been done for a number of possible reasons.

• The most likely reason is that the post was off topic.
  
• The topic could also have contained images or a video that were not appropriate to the original forum it was posted in.
  
• The images might not have been "illustrative" or "explanatory" in nature.
  
• The topic could have been moved because we deemed it to be more appropriately placed elsewhere.
  

Please ensure that your posts are "on topic" and contain illustrative images or videos as appropriate. Do not post videos or images just for entertainment purposes anywhere but in the screen shot or video forums.

 

Members who continue to post off topic posts can be denied entry to specific forums in order to reduce and remove the practice. Your cooperation is appreciated.