Hi.. I have an issue adjusting the elevator trim. I load up the 737-800NGX WL (startup state = NGX DEFAULT) and the trim is set to 4.0. In FSX control settings I have it set so that buttons 12 and 11 on my CH yoke adjust the elevator trim up and down respectively... it works fine in default aircraft but in the NGX pressing button 11 is not having the desired effect i.e. I cannot reduce the trim value. Increasing the trim value with button 12 works fine. I've tried different key and joystick assignments but to no avail - trimming up works, trimming down doesn't. Any ideas?

In the NGX 4.O is as far down as the trim goes, have you tried trimming up and then trimming down ? Just asking.

yes - sorry should have mentioned that. So I can trim up to any value but it will not trim back down.

It will work after you complete perf init. I noticed the same thing today.

 

 

 

Thanks... I'll give that a try

 

Sent from my AZ210A using Tapatalk 4 Beta