Looking for information on how to set up the Throttle sensitivities for Prepar3D.   It works fine in FSX but I am getting one of the throttles always moving from 0 to midpoint when both throttles are in the 0 position.  If anyone has a similar problem and maybe figured this out I would appreciate it.

Same place as FSX...  

 

Thank you for your response.  Mine is set up just like that.   It is not like FSX I have tried several of the default aircraft and still get the same throttle problem?

Interesting... I know this is a obvious question but have to ask anyway.. Did you calibrate it via Windows?   

 

You could also always try deleting the controls cfg and starting over.. Perhaps something went derp? 

I can tell that I had an hard time to fix my saitek with the same problem, so after searching, I found this and it worked.

Hi,

 

first unplug the quadrant.

 

Go to start/run and type regedit.

 

The registry editor will have a list of folders on the left hand side. Go down into the following folders in order.

 

HKEY_LOCAL_MACHINE (CURRENT_USER )

System

CurrentControlSet

Control

Media Properties

Private Properties

Direct Input

 

Inside the Direct Input folder, delete any folder that begins VID_06A3.

 

Once done, close the editor. Plug the quadrnat back in and move all the axes through their full range of movement 4 times.

 

Now go to control panel/game controllers/properties to see if everything is ok on the test screen.

 

 

 

 

Inviato da mio iPad utilizzando Tapatalk