Hi all

Just wondered if anyone has had this and has a solution

I've just installed the StMaarten scenery 1.7 and have no jetways visable (I have all options ticked to install in the setup)

I however have an aircraft embedded in the terminal with only the tail showing so I think this might be similar to the orbx and UK2000 airports problem that causes an identical problem.The only problem here is that I have no other scenery installed for ST Maarten to delete that that file including the default fsx file which I have disabled.

Any ideas on a fix

Thanks

If the building you are seeing is a gigantic generic terminal building then you have the same problem I did which was with the PW Caribbean sceneries (freeware). Maybe you have this installed and forgot? It has a special tick box in the installer for Fly Tampa St Maarten compatibility. If you installed or upgraded TNCM after this freeware was already installed then you will have the issue. The fix is to re-install that freeware scenery package with the FlyTampa compatibility checked. Hope this helps...

sounds like that maybe the problem as I have that installed will give it a try and report back

thanks

 

 

update:    Thanks Thetford  worked a treat, I've added the fix to the msg over at Fly Tampa as they were talking about afcad files etc  rather than this solution

thanks again

Pete

No problem. I had the same issue and just happened to remember the fix.

 

Brandon