Hi all

This is a bit of a duplicate post as I've asked this question on the Pmdg section ,but I've posted here as it might be an fsx thing

I am having trouble getting my elevator trim nose down to go past the green band If I then use a mouse on the trim wheel I can get the full nose down trim deflection,this only seems to happen on my pmdg 737 and 777 aircraft.The elevator nose up works fine but nose down seems to be a problem.

I have a registered copy of fsuipc which I've setup ok but this problem seems evident weather I use the keyboard option for elev trim or fsuipc.

I've tried them individually and together always with the same result.

I'm fairly certain everything is ok as I also have the A2A 172 setup to use the same button and on this I get full elev trim down deflection

All my aircraft are setup in fsuipc with type specific so I don't think I've any duplicate controls set in there

Can anyone shed any light as to why this might be happening

Did you check out the AVSIM Controller Forum in the Hardware section?

 

Best regards,

Hi Jim

Yes I've had a look ,might have missed something, but as it sort of works its hard to get a definitive answer

In the a2a Cessna I get full nose down trim ,but in the pmdg aircraft I've tried, I only get it as far as the top of the green band, as I said in original post this may be a pmdg thing and nothing is wrong at all, but was posting on here as well in case other Saitek /pmdg users have the same problem or if its me and I need to find a solution.

at the end of the day its not the end of the world as you normally set and forget most of the time just wondered if it was a problem or not

rgds