January 31, 201412 yr I can't get a grip on the keyboard parameters in FSUIPC. I have taken one of my Axis and set it up to raise gear and lower it for the PMDG 737 NGX, easy enough. Then I read in the manual that you can assign "Key Presses" to an axis. So I setup the axis with 3 events. The top portion of the stroke to raise the gear going "up", the bottom portion to lower the gear going down the center portion to turn the gear off, going down. The gear off is done by key presses - CTRL + G. This is where I don't get it. The key press is set in "Parameters" under "Control sent went range entered" in "This side to send button controls" in "Axis Assignment" tab. In the "Advanced" manual there is a key parameter reference section that is a bit confusing to me. For "CTRL + G" I thought I needed The "parameter" 71 + 2, but it doesn't work. Anyone get how the parameters work, thanks. Ric Elmore
January 31, 201412 yr Author Try Pete Dowsons forums Yeah, as soon as I posted this I thought "should have posted it on the FSUIPC forum". Ric Elmore
January 31, 201412 yr Posted 30 December 2013 - 11:05 AM Get the FSUIPC interface running and look for Button & Switches....then left click on it, then press the button you wish to program and the number of that button will appear in the right hand side of Joy# and Btn#...thenclick in the box Select for FS control.. a tick will appear..Now,go down one and click on the black arrow under Contol sent when button pressed...A list will appear..select off that list what you require and left click on it...That`s it easy.............If you want your selection to repeat, left click in the Box Control to repeat while held.........go to the bottom and click OK...Job Done....... Hope that helps Brian. Hope this helps you......... OR try LINDA................
February 1, 201412 yr Author Posted 30 December 2013 - 11:05 AM Get the FSUIPC interface running and look for Button & Switches....then left click on it, then press the button you wish to program and the number of that button will appear in the right hand side of Joy# and Btn#...thenclick in the box Select for FS control.. a tick will appear..Now,go down one and click on the black arrow under Contol sent when button pressed...A list will appear..select off that list what you require and left click on it...That`s it easy.............If you want your selection to repeat, left click in the Box Control to repeat while held.........go to the bottom and click OK...Job Done....... Hope that helps Brian. Hope this helps you......... OR try LINDA................ I'm not programming a button. I am programming an axis to send a key press. Thanks anyway. Ric Elmore
Create an account or sign in to comment