Hi everybody,

 

I tried this afternoon an engine failure, and to my surprise, I couldn't feather the dead prop. After several attemps, I just gave up.

Then I landed, and after the engine shutdown, I noticed the pitch of the props just don't change as you set the prop levers to feather...
(on their Seneca II, there was no prb to feather at all)

Thank you to confirm or maybe I missed something here?

 

Concerning the ADF, I can't set the ADF needle on the G600!!

Very annoying when making NDB approaches :-(

I noticed the ADF module just don't switch from stdby to active freq...

Maybe Bert can help on this one...?

 

Thank you

 

Emmanuel

 

 

Sounds like possible operator error. Check out the screenshots with an engine feathered in the Avsim review. http://forum.avsim.net/page/index.html/_/reviews/aircraft/review-carenado-seneca-v-r2619

 

Regards,

 

Ray

Hi,

 

and thanks for your reply.

Actually I figured this week-end that my prop levers weren't correctly calibrated, and as I don't see them in the VC due to a 'realistic' POV positionning... it took me a while since I discovered that... :-(

Now it works perfectly.

 

Emmanuel

I cannot get the prop to feather either, setting a button in settings doesn't do it, saitek throttle doesn't do it, and I can't do it with the mouse either. Any suggestions?