I've installed a fresh install of P3D v2.4 and VoxATC 6.49.  However, when I try to enable VoxATC from within an aircraft, I'm getting a 'FATAL ERROR. Disable VoxATC' message.  I've tried reinstalling VoxATC several times and I have made sure the voice recognition is turned on.  I can run the indexer just fine and can install VoxATC into any aircraft.  I also load up a short flight as well.  It's just that when I try to enable it within an aircraft to use it, I see this error.  It happens every time.

 

I had no problems with VoxATC in previous versions of P3D.

 

Any suggestions I can try?  Is there any confirmations that P3D v2.4 and VoxATC work properly together?

 

Thanks.

Do you have a flight plan loaded before starting VOXatc?

 

Maybe double check the manual?

Is the problem fixed???

If yes, can you explain the solution?

I had to reinstall my P3D and VoxATC and now everytime I try to start VoxATC I get the message "FATAL ERROR"...

All other VoxATC-Items (Indexer etc.) works well!

Hope to get an solution for this problem...

I get this in FSX every time unless I have loaded a flight plan into FSX, it could be the same issue.