If any of you have had this problem and know how to cure it please let me know!!!

 

   I Just installed a Saitek yoke quadrant and rudder pedals... I use them on xplane 10 and work fine but when I try to use them in

fsx the breaks won't release in any plane..... any thoughts??

Try adjusting your sensitivity and null zones. I had the same problem before.

when I try to use them in

fsx the breaks won't release in any plane..... any thoughts??

 

You need to check the 'reverse' box when setting up the axes for the toe brakes.

 

P.S. If using FSUIPC, it also helps to make sure you have a bit of slack at the bottom (brakes off) end of the range or you may see the little red 'differential brakes' message when you take your feet off.

Thank you gentlemen...I will give this a try...Will keep you advised.....