I am running P3Dv3 and have several addon sceneries and airports installed. Generally I have left the order in the Scenery Library as set by the installer, then checked to make sure there were no issues. The Orbx sceneries (Global, OpenLC EU, regions  and airports) always install in the correct order and stay that way. But I have had a problem with Sim 720 and UK2000 airports.  I generally have to go into the Scenery Library and make sure the airports are above the region where they are located. They generally are set by the installer under these regions, so  I move them up where they should be, then carry on flying for the session. But when I exit P3D and start it at a later time, the airports all move back where they were. So I have to go back and reset them correctly - very time consuming. Has anybody else had such a problem where sceneries change order when you turn off and restart the sim? Can anyone suggest if this is a problem, and if there is something I can do to make sure that the Scenery Library order stays put between sessions?

Is it possible your FTX insertion point is being reset by Orbx FTX Central? Try putting the Orbx insertion just below those problem entries and see if they stay there.

 

Vic

Is it possible your FTX insertion point is being reset by Orbx FTX Central? Try putting the Orbx insertion just below those problem entries and see if they stay there.

 

Vic

Thanks, I will give it a try.