Apologies if this has already been asked before.

 

If you save your flight say in the cruise within P3D and want to continue the flight at a later time, once you open up FS2Crew again after P3D restarts and continuously press the down arrow on the FS2Crew panel to the last procedure and select it, it doesn't seem to flow properly later on such as during the decent. For example the under 10k procedure starts at 17000 feet, where it would normally start at 10k; correct point if I hadn't of restarted P3D and FS2Crew (NGX reboot button control).

 

Any suggestions?

 

Thanks

My only idea:

 

The 10K procedure could start above 10K if you are landing at a high elevation airport.