Hello!

 

I got an engine failure these days in which TAC was ON and trimmed accordingly. After landing and maintenance provided the rudder trim never got back to center position after pressing Manual Trim Cancel button. It always remains to the left a few units, and it affects taxi. I tried reseting TAC, even a battery-out, but nothing solved the behavior. What's going on?

 

Thanks!

 

 

What's going on?

 

Sounds like hardware interference. Check your axis assignments.

It probably worked! Among other things I disconnected the hardware and connected it again, now it's centering spot on. I didn't suspect on this at first because the Flight Controls page never showed a deviation for the rudder... Anyway, now it's just fine!