Hello,
I have just purchased Chaseplane. Managed to set up the views in VC. Able to zoom in and out with key assignment. Pan & Tilt using the joystick hat buttons. So far, very happy with the interior settings.

 

However, when in exterior view, I only can pan around the aircraft, can not move up or down. I have read in the forum and I believed this is what we have for now and will be updated later in Alpha 2? If so, can I not use Chaseplane in exterior and use FSX default pan instead? Or how can I pan and tilt around to look outside?

 

In addition, when pan & tilt outside or inside the aircraft, it affects the other one at the same time. Is there a way to stop it?

Thank you,

Hoang Le

Hi,

 

In Alpha 1.5 (0.1.5xx) you can move around Spot View in supported simulators using the same buttons you assigned to move up/down/right/left.

To move around the aircraft freely, make sure you use the Outside view mode supplied with ChasePlane.

 

Regards,

Keven

Hi,

 

In Alpha 1.5 (0.1.5xx) you can move around Spot View in supported simulators using the same buttons you assigned to move up/down/right/left.

To move around the aircraft freely, make sure you use the Outside view mode supplied with ChasePlane.

 

Regards,

Keven

Hi,

I can move around spot view by using the HAT, but it will also move my view in VC simultaneously. Is there a way to separate chaseplane VC and FSX spot view so it don't affect each other?

For now I don't use the outside view in Chaseplane because I still prefer the way default spot view works (viewing around the aircraft), but I have not managed to get it working. Or it can not?

Thank you

Hoang Le