In the latest experimental version, when using any of the static cameras at an airport, the camera shakes are a lot.  I wasn't sure what was causing it, until I found out it didn't start doing that unless I had AS16 open.  I went into the camera settings, and turned the turbulence bar all the way down, and that stopped it.

However, if i change to a different camera view, it doesn't save my setting and the turbulence is turned back on.  The check mark to save the setting is greyed out.  Is this something that can be fixed?

 

thanks,

 

This is caused by the wind turbulence. Will be fixed in the next version

Thanks for the report!

Hi

 

Yes, same problem here!