p2a hangs/freezes and wrong vectors (vs *18)

[MindYerBeak 73]

I did a flight ENGM  getpa koret latku kelin lalil topla atrib EKCH and after awhile the software started hanging so I restarted it  and  contacted center and resumed flight....it hung froze and gave me  strnge vectors

 

logs -> https://pastebin.com/dMT7RSCu

[Dave-Pilot2ATC 870]

It looks from the log like all was OK until you did the go-around.  Then I can see the vectors seem to have not been consistent.

If you press the APPR button to the right of the map, that will show what path the controller is trying to vector you on.  A screenshot of that next time something like this happens would be helpful.  It's very difficult to tell where you should have been vectored vs the vectors you were getting.

It's possible that ATC didn't pick up on a point being passed and tried turning you around to get back to that point in the pattern, but again, hard to tell without more information.

I'll try flying a similar route and fix any problems I find for  the next update.

Thanks,

Dave

 

[MindYerBeak 73]

17 hours ago, Dave-Pilot2ATC said:

A screenshot of that next time something like this happens would be helpful

when the softare freezes it just stops and nothing moves.nada