Hi all-

Can the GTN 750 GPS window be assigned a keyboard sequence to open and close vs clicking on the stack? I wouldn't mind substituting Shift + 2 to it instead of the stock GPS but don't know how to do it.

Cheers,

Mark

Yes. depends on which aircraft. Look in the panel.cfg file near the top. The "clickable" windows are usually listed. Whatever number is assigned to the GTN - use the next higher. So if panel says Window 06 = f1 gtn 750 etc..... you would use shift 7 to open the window.

Vic

Hi Vic-

It's the XtremePrototypes Lear. I'm not at home right now but will check it out when I get home. I think Bert had a panel cfg edit that put it into the panel but not sure.

 

Thanks,

Mark

In my case it assigns it to spot 13 in my A2A aircraft and therefore you can't use a keyboard shortcut. However I open the panel.cfg file for each specific aircraft and swap the contents of [window 4] with [window 13] because I don't open the default P3D maps. Also at the top of the config file I change the name of Window04=GTN 750 and make Window13=Map. This allows me to assign the maps key to open and close the GTN 750 I also assign that key using Voice Attack so I can open and close it with a voice command. 

Additionally I do the same for my A2A T6 using the GTN 650

Hope this helps

Joe

Mark - Joe's method is the easiest if the window assigned is > 9. 

 

Vic

Thanks guys I'll check it out. 

Cheers,

Mark