November 15, 20178 yr I have P3DV4 installed and discovered the existence of wind farms (those wind turbines) during a flight between the Isle of Man and the coast of England. There were hundreds of wind energy scanners on the sea, close to the VOR WAL (114,10), but after the installation of the ORBX products they are simply gone, the sea is clean. Has anyone else had this problem? One tip on how to restore such landmarks? Or what files should I restore to get back? Thank you
November 15, 20178 yr Moderator 3 hours ago, Gilmar Leal said: I have P3DV4 installed and discovered the existence of wind farms (those wind turbines) during a flight between the Isle of Man and the coast of England. There were hundreds of wind energy scanners on the sea, close to the VOR WAL (114,10), but after the installation of the ORBX products they are simply gone, the sea is clean. Has anyone else had this problem? One tip on how to restore such landmarks? Or what files should I restore to get back? Thank you Oi, tudo bem? Welcome to Avsim. As far as I am aware, the windfarms are part of the ORBX product and not default. You could make sure that they are enabled in the ORBX Control panel. The only other reason they might not appear that I can think of is if the scenery complexity slider is not turned up high enough, but I’m not sure ORBX tied the windfarms to that slider or not. Avsim Board of Directors | Avsim Forums Moderator
Archived
This topic is now archived and is closed to further replies.