Since installing the new version with the altered export plan function, my X Plane 11 fms plans are not readable using the RWDesign A330-300. The plan shows in the FMC but loading only produces a plan with the start and destination waypoints, the airports with Direct in between. Any ideas?

You may need to export as an XP10 plan as the XP11 export is a new format that might not yet be supported by your aircraft.

Dave

I notice that although the plan displays properly in pilot2atc with correct nm distance the exported file is 8220nm instead of 122nm.

Please email me the flight plan so I can test it.

[email protected]

Thanks,

Dave

 

An additional thought on the original post. 

If you don't have any en-route waypoints defined, meaning just the airports and SID, STAR, Approach, then the exported flight plan would only show the two airports.

Sorry I should have been clearer, the FMC shows only the departure and destination airports, will try the xplane 10 export as I suspect that this may work with the particular aircraft.