Hello,

I recently purchased the Fs2crew for my maddog MD82 and installed it as instructed. But the main panel refused to open when i clicked the MFD. I have checked the panel to see if the gauges were installed and yes they are there. I have ran the registry repair tool and have re-installed but still no show. I have also checked the registry test in the fs2crew manager and yes it has shown the link. So why doesn't it appear when I click in both the 2D and  the VC panel.

Thanks

Hi,

Is this for the Legacy version or Reboot?

I'm guessing Reboot.

Why are you clicking the MFD?

To open the Main Panel, tou need to assign a key to AUTOFEATHER ARM/OFF.   I suggest using the "N" key.

Please check the manuals again at: www.support.fs2crew.com

Also ensure you enabled FS2Crew via the Maddog Load Manager.  There's a screen shot in the FAQs thread and our manual.

Best,

 

Hello.

I tried assigning  the letter N to AUTOFEATHER ARM/OF, but it still does not show the main panel. My version is legacy, and I cant see the screenshot to enable the Fs2crew in the FAQ section. Could you please share a link or paste it here for me to use.

Thanks

Since you're using the old Legacy version, please disregard what I wrote above.

Everyone is using Reboot now, which is different.

For Legacy, you need to use the FS2Crew Maddog Config Manager.

Ensure everything is run with Admin rights to avoid write permission issues.

Double check the old Legacy manual.