Lost use of zoom

[pedwards]

Yesterday I have lost use of the zoom feature in P3D v4. It has worked using the allocate ChasePlane keys Num Plus and Num Minus. If I revert camera .cfg to bring back the Virtual Cockpit, the default P3D keys work fine and the view changes. 

It may help but the view using ChasePlane is stuck at .20% (very wide angle).

Thank you.

[Keven Menard]

Hi,

Do you get an error message about that issue?

[pedwards]

Hi Keven,

There was no error message, however I believe I found the issue and it is not with Chaseplane (CP). At time I use VR (not with CP) and before the issue I had tried the new imporved P3D VR support. It seems that the view failed to reset following a VR session and therefore the display was stuck on x.20 view. I swithced on the VR and then off again and was able to adjust zoom.

Regards