Why is it that every time I close the sim,, this error box flags up.?

At first I thought it pertained to FSL's A319 because it kept happening with that particular aircraft every time I exited the Scenario, and closed down the sim. However, since then I have Updated the FSL aircraft to the latest versions, yet this ContentsError keeps cropping up. And that after having run Content.msi.

Any ideas, folks?

[error.0]
error=Found Duplicate Key Name
 File:C:\FS\SimObjects\Airplanes\PMDG 737-800NGX WL\texture.WN\texture.cfg
 Section:fltsim
 Key:fallback.3

[error.1]
error=Invalid Texture name "DDS" specified for model "vc".

[error.2]
error=Payload station "NLG Brake Station" exceeds maximum name length of 16.

[error.3]
error=Payload station indexes should be between 1 - 16

[error.4]
error=Texture FSL_Eng_Icing_000.bmp failed to load (FE_REQUEST_STATUS==13)

[error.5]
error=Texture FSL_Eng_Icing_000_bump.dds failed to load (FE_REQUEST_STATUS==13)

[error.6]
error=Texture FSL_Rain_000.bmp failed to load (FE_REQUEST_STATUS==13)

[error.7]
error=Texture FSL_Wiper_063.bmp failed to load (FE_REQUEST_STATUS==13)

[error.8]
error=Texture FSL_Eng_Icing_000.bmp failed to load (FE_REQUEST_STATUS==13)

[error.9]
error=Texture FSL_Eng_Icing_000_bump.dds failed to load (FE_REQUEST_STATUS==13)

[error.10]
error=Texture FSL_Eng_Icing_000.bmp failed to load (FE_REQUEST_STATUS==13)

[error.11]
error=Texture FSL_Eng_Icing_000_bump.dds failed to load (FE_REQUEST_STATUS==13)

[error.12]
error=Texture FSL_Eng_Icing_000.bmp failed to load (FE_REQUEST_STATUS==13)

[error.13]
error=Texture FSL_Eng_Icing_000_bump.dds failed to load (FE_REQUEST_STATUS==13)

 

Under Options - General, disable "Enable Content Error Reporting". Not sure why you have this enabled, it is intended to help debugging content. The scan is very intolerant, lots of the reported issues do not really hurt (e.g. the Payload station indexes error). On my PC, having this option enabled hurts performance so I only use it when I want to test add-ons.

Edited August 14, 20187 yr by hschuit

Many thanks for that heads-up.

I did not even enable it. Just installed P3D v4.3.29 straight from installer.

Now, will try that tip and see if I can make an FSL A319 flight, at least.