Hi, SHIFT + Enter and SHIFT + BACKSPACE etc. don't work with the 2d panels. It only works with the VC. Will this get fixed with final release? Jan-Paul

They do work on the ground in 2d view but move quite slow. you have to hit the keys quite a few times. I could not however get them to work while in flight.If you use a hat switch go to your cameras.cfg file (its in the same folder as the fsx.cfg file ) and make this change in cameradefinition 001 cockpit section. This may even help with the shift keysPanPbhAdjust = SwivelPanPbhReturn = False//PanPbhAdjust = Ordinal>>>>default//PanPbhReturn = True>>>>>>default

Hi, thanks for the tip. The panel is moving up and down, but the view angle doesn't change like it was in fs9. Jan-Paul

Yes you are correct the angle stays the same which defeats the purpose and can make approaches difficult.The angle does seem to change however when I use my hatswitch on the CH yokeBill

>Hi, >>SHIFT + Enter and SHIFT + BACKSPACE etc. don't work with the>2d panels. It only works with the VC. Will this get fixed with>final release? >>>>Jan-Paul There are new commands just for the 2D panel. Check the control assignments list.

Hi, I have only seen the transparancy function. But nothing to pan the view.

>Hi, >>I have only seen the transparancy function. But nothing to pan>the view. CTRL+Q and CTRL+SHIFT+Q. Press and hold.

@tdragger, Ah.. got it. Did you get my pm, e-mail regarding panel lights switch and sub panels? Jan-Paul

I usually don't read PM. What was your question?

Hi, when you enable the panel lights SHIFT + L, the hourglass shows up very very short (panel opens instantly) and creates a small pause of the aircraft motion. The same thing happens also to some (not all) subpanels like the radio stack This happens only when opening subpanels not when closing. http://forums.avsim.net/dcboard.php?az=sho...=9933&mode=fullJan-Paul

push up

>>Hi, >>>>I have only seen the transparancy function. But nothing to>pan>>the view. >>CTRL+Q and CTRL+SHIFT+Q. Press and hold.Welllllll..... I guess :) BUT I sure miss using the hat switch to pan the view 360 in 2d mode.As a FYI on another matter - I understand that F10 & A will toggle 2d & VC but I noticed that the NUM 0 also acts like F10. No big deal, just FYI.VicVisit the Virtual Pilot's Centerwww.flightadventures.comhttp://www.hifisim.com/Active Sky V6 Proud SupporterRadar Contact Supporter: http://www.jdtllc.com/