Clear of Active Response

[sbclark 55]

Hi Dave,

Glad to see you are back on the forums.

Have not flown P2A much lately, unfortunately life intervened, but have started flying again with ATC again. The immersion factor it provides makes a huge difference, and your software is really good.

Noticed today when clearing the active after landing, I gave a "<Call Sign> Clear of Active" report, and it was not recognized for some reason.

When I looked under the Grammer Helper I could not find this phrase, it used to work. Is this action is sill in the latest version of P2A, and if so, is it under GND or Tower?

Bill Clark

[GKELLERMAN 7]

It's located in Grammar helper under: Tower; Report; Pattern location: <callsign>is clear of Active

I have trouble getting recognition using that format but "Clear of active <callsign>" works for me 99 percent of the time.

[sbclark 55]

Thanks

As I recall, it used to work for me. I will look under pattern location.

Bill Clark 

[Dave-Pilot2ATC 873]

Thanks Bill.

"<CallSign> is clear of active" or "<CallSign> clear of active" should work on Tower frequency.  There might have been a speech recognition issue for some reason that caused it to not work.

Dave

[sbclark 55]

Thanks Dave, I just could not find that phrase in the SayIt list, I will take another shorter flight today to see if I can make this work.

It probably is a voice recognition issue.

Bill Clark