Remote overhead panel 777, no button/switches showing

[furger 12]

Hi Mark

I am facing a problem with the remote overhead panel for the 777 i.e.

- license is showing ok

- overhead client (OverheadClient.exe) is running fine (running on the PC where Prepare3D is installed)

However, when opening the given http address for the overhead panel on my iPad, just a blank sreen is disclosed (verified on two different remote devices [both running iOS]). When clicking anywhere on this blank screen then the ovehead tableau is showing. But there are no buttons, switches, etc. SimServer is also dislcosing "Connected Devices: 0". CDUs are running fine on the same device. Restart of SimServer does not help.

Any idea what I should check?

Thank you for the support.

Best regards

Andreas

[furger 12]

Hi Mark

I just realised that when I doubleclick on the non-functional overhead panel (intended zoom) I end up with the following error message.

Above probably might help you in analysing the problem I am facing . . .

[marcom 139]

22 minutes ago, furger said:

Hi Mark

I just realised that when I doubleclick on the non-functional overhead panel (intended zoom) I end up with the following error message.

Above probably might help you in analysing the problem I am facing . . .

Hi Andreas,

which browser are you using?

[furger 12]

Hi Mark

In the iPad I have tried unsuccessfully with both Safari and Firefox.

[marcom 139]

3 hours ago, furger said:

Hi Mark

In the iPad I have tried unsuccessfully with both Safari and Firefox.

Ok can you please send me your logfile via email after you connect via Safari?

[furger 12]

Just sent to you.

[marcom 139]

Ok, so the issue here was that the browser used was simply too old.

I've added a sanity check that shows a corresponding warning.