I have always used PFE/PF3 on a client PC in MSFS/P3D.

Can PFEtoXplane work with PF3 installed on a networked client? 

Same question about RC4toXplane. 

Are there limitations when using PF3 or RC4 in X-Plane compared to P3D?

 

Thanks,

12 hours ago, Dirk98 said:

I have always used PFE/PF3 on a client PC in MSFS/P3D.

Can PFEtoXplane work with PF3 installed on a networked client? 

Same question about RC4toXplane. 

Are there limitations when using PF3 or RC4 in X-Plane compared to P3D?

 

Thanks,

There are a few restrictions with regards using RC4 and PF3 in X-Plane.

Cannot operate them in a networked configuration, as XPUIPC is not a full equivalent to FSUIPC and WideClient configuration

Currently, they cannot see X-Plane traffic. This may be added later, once third party traffic packages are up there.

Radar Contact ATC cannot relocate aircraft on startup, therefore, before you click <Start RC> in order to connect to X-Plane, make sure the airplane is positioned at the departure airport as per your flight plan.

Everything else should work as expected.

43 minutes ago, FS++ said:

There are a few restrictions with regards using RC4 and PF3 in X-Plane.

Cannot operate them in a networked configuration, as XPUIPC is not a full equivalent to FSUIPC and WideClient configuration

Currently, they cannot see X-Plane traffic. This may be added later, once third party traffic packages are up there.

Radar Contact ATC cannot relocate aircraft on startup, therefore, before you click <Start RC> in order to connect to X-Plane, make sure the airplane is positioned at the departure airport as per your flight plan.

Everything else should work as expected.

Can I communicate with ATC (RC/PF3) by voice, like you did for MSFS/P3D?

Thanks,

1 hour ago, Dirk98 said:

Can I communicate with ATC (RC/PF3) by voice, like you did for MSFS/P3D?

Thanks,

Yes, provided you own MCE for X-Plane, which is a separate product from Multi Crew Experience Ultimate for Prepar3D/FSX/FS9