Hi, with the new version when I receive ATC messages the view in the sim changes to show the radio view. So the front view changes for the radio view, very annoying when you are landing. This was not happening with the previous version.  I use chaseplane, but the radio view is not one I define in chaseplane. it seem to be the one define in P3D (default). Also If I recall, MCE had a option to increase the static noise when using the PUSH to talk button, I do not see the option anymore.

Thanks

Pierre 

38 minutes ago, PierreFSX said:

Hi, with the new version when I receive ATC messages the view in the sim changes to show the radio view. So the front view changes for the radio view, very annoying when you are landing. This was not happening with the previous version.  I use chaseplane, but the radio view is not one I define in chaseplane. it seem to be the one define in P3D (default). Also If I recall, MCE had a option to increase the static noise when using the PUSH to talk button, I do not see the option anymore.

Thanks

Pierre 

No such thing deliberately built into MCE.

Best guess is something re-acting to event KEY_ATC.

Make sure you don't have assignment in FSX/Prepar3D for ATC key (usually " ' ") to open radio panel or switch view.

You may want to reset MCE to factory settings so that any eventual issue with config file is cleared.

Start->All Apps->Multi Crew Experience->Restore factory settings.

You'll have ti go through the wizard. However, there is no need for speech training.

You can adjust static noise as follows.

Right-click anywhere in MCE UI  and select droip-down menu Use static noise->Low/Med/Max

I assume by latest you meant V2.8.0.6

 

 

Thank you for the reply I will investigate the assignment in P3D.

Pierre