December 17, 20196 yr I posted this in someone else's thread so might not have been seen. There is a bug in v1.4 of the NGXu module described below: The reworked MCP2 display has a bug. It is displaying the following: During climb in VNAV mode: N1*to Dest: 0 nm At top of climb it switches to: SPD to Dest: 0 nm I did have a flight plan loaded in the FMC. Eric
December 18, 20196 yr Hello Eric, haven't had the time to fly recently. Will have a look ASAP, hopefully in the much quieter holidays soon Guenter Steiner -------------------------------------------------------------------------------------- Betatester for: A2A, LORBY, FSR-Pillow Tester --------------------------------------------------------------------------------------
December 31, 20196 yr Author On 12/18/2019 at 1:24 AM, guenseli said: Hello Eric, haven't had the time to fly recently. Will have a look ASAP, hopefully in the much quieter holidays soon By chance Guenter have you had an opportunity to look at this over the holidays? Eric
January 1, 20206 yr Hello Eric, yes, have tried it now. But can't reproduce ... do you have any steps to reproduce it? Oh, and do you run on the very latest FSUIPC? Edited January 1, 20206 yr by guenseli Guenter Steiner -------------------------------------------------------------------------------------- Betatester for: A2A, LORBY, FSR-Pillow Tester --------------------------------------------------------------------------------------
January 15, 20206 yr Author On 1/1/2020 at 12:10 PM, guenseli said: Hello Eric, yes, have tried it now. But can't reproduce ... do you have any steps to reproduce it? Oh, and do you run on the very latest FSUIPC? That was it, I was one version behind. Works now. Thank you Eric
Archived
This topic is now archived and is closed to further replies.