April 5, 20206 yr When pushing back with UGCX the FO will call starter cut-out immediately when calling to start engines. If I don't use UGCX I don't have this issue.
April 6, 20206 yr Commercial Member That has nothing to do with UGCX and everything to do with this 🙂 Question: During engine start, the FO says "STARTER CUTOUT" way too soon and starts his after engine start procedure before I even started the engines. Answer: You have a button or hardware lever assigned to the FS "MIXTURE CONTROL" command/event. Delete that. FS2Crew reads the position of MIXTURE CONTROL to determine the position of the Start Levers. B. York FS2Crew Web Site / FS2Crew Facebook Page / FS2Crew Discord
April 6, 20206 yr Author 11 hours ago, byork said: That has nothing to do with UGCX and everything to do with this 🙂 Question: During engine start, the FO says "STARTER CUTOUT" way too soon and starts his after engine start procedure before I even started the engines. Answer: You have a button or hardware lever assigned to the FS "MIXTURE CONTROL" command/event. Delete that. FS2Crew reads the position of MIXTURE CONTROL to determine the position of the Start Levers. That was it. My key assignment for PTT or start pushback for UCGX was the same as the keyboard command for the mixture. Edited April 6, 20206 yr by CaptainBanages
April 7, 20206 yr Commercial Member Glad it's sorted 🙂 B. York FS2Crew Web Site / FS2Crew Facebook Page / FS2Crew Discord
Archived
This topic is now archived and is closed to further replies.