Hi folks

I recently was given the logitech switch panel (I already hav the Yoke and Throttle quadrant.)

How on earth is it configured? I went to the link given, downloaded the test program and the advised driver file. and all switches, gear lever etc all work when running the test program, its connected via usb slot on the yoke.....But in Sim nothing. I've attempted, settings, buttons/levers, Landing gear for example. and gone to new assignment. then moved the lever from gear down to up or vice versa, but nothing... Tried change assignment and still nothing. Looked on logitech support, but that seems decidedly lacking. 
I'm hoping many on here use it and can advise
This is for FSX Steam edition

Edited June 27, 20205 yr by coreservers

Hi, 

What I think you may not have realised is that you need to download not only the panel driver but also a simple specific driver-it is on the site but not obvious if you are not looking-these is one listed for fs, p3d, xp, few some have 16bit and 64 bit versions depending on you pc

Also if you want to program them as well you can use SPAD or using a registered FSUIPC with the hidswitch.lua from Pete Dowsons site. 

 

Best wishes

 

Ashley

lovely thanks. that is a hidden file. but got it all working now.. so much better than just pressing L and G ... 😀

Can you lead me to the driver downloads path/file.  I cannot find anything on their site regarding pro flight drivers.  Thx.

 

Nevermind... it appears to be just a simple plug-n-play as they are recognized as I plug them in.

Edited July 14, 20205 yr by Clutch Cargo
found answer