September 10, 20205 yr Commercial Member This normally happens when AIRAC cycles are out of sync causing procedures to be slightly different or if the loaded flight plan in the plane does not exactly match the one in P2A. Dave
September 10, 20205 yr Author 1 hour ago, Dave-Pilot2ATC said: This normally happens when AIRAC cycles are out of sync causing procedures to be slightly different or if the loaded flight plan in the plane does not exactly match the one in P2A. Dave AIRAC in XP and P2A is the same, how more I zoom out the closer the plane comes to the line. Flightplan was exported from P2A into the the Airbus Frank J. Herter
September 10, 20205 yr Author Again far away from the drawn course. Additional ATC guide me to the wrong RW should be 28 but shown is 10 and instructions given to RW28 (Taxi Mnt was done) Frank J. Herter
September 10, 20205 yr Commercial Member When flying a procedure, as in the top screenshot, it is highly likely that your FMS will be flying the procedure as it thinks it should be flown and P2A draws it somewhat differently. That is not a problem and can be ignored. On the second screenshot, the taxi instructions are not visible. However, the SID is from runway 28 and you were cleared for takeoff for runway 28. Even though your flight plan is for departure on runway 28, you can request and be given taxi instructions to runway 10. If you don't request a new departure runway, when you arrive at RW 10 and request departure from tower, you will be told to contact ground for taxi instructions to get you to RW 28. Dave
September 10, 20205 yr Author 1 hour ago, Dave-Pilot2ATC said: When flying a procedure, as in the top screenshot, it is highly likely that your FMS will be flying the procedure as it thinks it should be flown and P2A draws it somewhat differently. That is not a problem and can be ignored. On the second screenshot, the taxi instructions are not visible. However, the SID is from runway 28 and you were cleared for takeoff for runway 28. Even though your flight plan is for departure on runway 28, you can request and be given taxi instructions to runway 10. If you don't request a new departure runway, when you arrive at RW 10 and request departure from tower, you will be told to contact ground for taxi instructions to get you to RW 28. Dave I sent you the log-file via email. Didn't understand why ATC guide me to RW10 instead of 28 Frank J. Herter
September 10, 20205 yr Commercial Member After looking at the log file you sent, I checked the taxiway definition and I believe the problem is in there. I will check the code to see why it didn't give instructions to the intersection closest to RW28. Thanks, Dave
September 10, 20205 yr Commercial Member I just tested requesting taxi from gate F3 to runway 28 and it gave me correct instructions to the closest intersection to RW28. Be sure you are on the latest version of P2A - 2.6.1.3 and try requesting taxi to RW28 from one of the gates. Dave
Archived
This topic is now archived and is closed to further replies.