January 9, 20215 yr I went through the 22 minute video from Honeycomb to set up the Bravo Throttle Quadrant; I downloaded the 'pre-made' PMDG 737 NGXu profile from the support page. I tweaked the key assignments in P3D v4.5. I cannot get the Autopilot to work; the IAS, HDG, etc do not engage. The landing gear lights will not come on, the annunciator lights (parking brake, APU, etc) do not light up. I must be doing something wrong, but have no idea what it is. Any suggestions? Dave Robinette NBL1936
January 9, 20215 yr Is the driver (AfcBridge) installed and runing ? See the P3D menu Addon. You should have an Honeycomb sub-menu... Gérard
January 9, 20215 yr Author I have a sub menu, but it ONLY gives to re-install/load the profile or to disengage the profile. The AFC_Bridge.dll is installed. All of those are installed in the Aerosoft folder that is on the same drive as P3d, but not within the P3D folder itself.
January 13, 20215 yr Author SOLVED. I had ACTIVATED the Honeycomb Configurator to work with PMDG. I selected the proper profile. But, I neglected to ACTIVATE CURRENT PROFILE. Once that was done, everything works just fine. David Robinette NBL1936
January 13, 20215 yr How do you activate the current profile? Also what assignments did you tweak in P3D? Edited January 13, 20215 yr by barramundilure Regards Barra i7 7700K, 16GB 3200MHz DDR4, GTX1070 OC 8GB, 1TB Samsung SSD for OS and P3D4.4, W10 64Bit, Corsair H115i Water Cooling
January 15, 20215 yr On 1/12/2021 at 8:29 PM, barramundilure said: How do you activate the current profile? Also what assignments did you tweak in P3D? here is a video that explain step by step how to make it work with PMDG. Honeycomb Configurator - PMDG Support - YouTube To answer your question you click on Actions and then on Activate current profile. You can launch P3D after that.
Archived
This topic is now archived and is closed to further replies.