I Have fs2020 and am using p2a with it. I have run make runway and imported taxi ways and gates. Only problem is when I get assigned a taxi route, it does not show on the map. that goes both ways; to the runway or the gates. Any answers would be appreciated

Thanks

Woody

 

If you get  an actual taxi route in the taxi instructions then press Taxi button to the right of the map will show that route.

Dave

Thanks Dave, I am trying to add taxiway route markers as there are none only the runways show. I have managed to add some now Taxiway A and B with some holds  B1 and A1 etc I seem to only be able to add two taxiway points though is this correct?

When I taxi now I just get a blue line down the middle of the runway with the (triangle) hold at the the end of the runway no taxiway route.

Sorry this reply was for another post, my apologies

Edited January 24, 20215 yr by ATCMikeR
addition

You can manually add taxiways and runways with multiple points.  Look on the Pilot2ATC.com Tutorials page for a video of doing this.

However, importing is always the best first step.

Dave