I just received a bravo throttle quadrant. I installed the proper drivers.  This is for p3dv4.5. Everything is working perfect except for the landing gear. The led lights are on but I can’t raise the gear. I’ve activated the profile but still the gear won’t go up or down. What am I missing?  Any suggestions would be appreciated. This is very frustrating. 
Thanks, Gerry

Hi,

 

Have you tried configuring with FSUIPC.

I allways ues it, it's so nice and easy.

Yves

Thanks I’ll give it a try. 

Everything else is working.  This should be working too. 

Have you desactivated the default assignements made by Prepar3D for a new equipment ?
They may conflict with the Profile configuration.

I had the case where a switch was making TWO actions...

The configurator will take care of that for you.

Gérard

FSUIPC didn’t work. The problem is it’s not recognized. I’ve installed and reinstalled the drivers without any success. 

I’ve tried disabling simulator defaults. That didn’t work either. 

Have you the Add-ons Honeycomn entry in P3D ?

Screenshoot extracted from "Basic test of the Honeycomb Bravo Throttle under P3D with the Honeycomb Configurator"

Gérard

I’ll check. 
By the way, I’m Gerald. Close!

Ok. A step forward. The led lights came on when I clicked on the BEF. Should be all green.  Have one orange light. But still the gear itself does not work. 
 

SB BFC. You know what I meant. 

Thanks

It seem that the gear lever is not activating.  I’ve checked it out with Windows game calibration. 
Thanks, Gerry