July 11, 20214 yr Greetings, re the title, the 2D pop-up installs without issue but the 3D in the panel does not install for either G530 or G430. For the Laminar B58, I simply prepared a a RXP .ini from the Aircraft Config thread, dropped it in the aircraft folder and all was good, including the 3D panel. The same practice for the C90B does not yield the same results. The file does contain this instruction: (only copy-paste the parts required into your .ini file) Is there a different or separate .ini file from RealityXP.GNS? I have installed several RXP GNS for various aircraft in P3Dv4.5 and XP11 and not encountered this problem. Has something changed?
July 12, 20214 yr Hi, Is this the one you're referring to?https://www.avsim.com/forums/topic/521970-official-panel-configuration-thread/?tab=comments#comment-3745349 My understanding is that the mod in this post only shows the sections which are relevant for displaying the gauges in the virtual cockpit, which you'll add to the existing RealityXP.GNS.ini file found in your C90 folder. If you don't have any yet, just load the aircraft and enable both the 530 unit1 and the 430 unit2, which are the ones this mod is using. Once done, you just need to copy/paste these into your RealityXP.GNS.ini file in the C90 aircraft folder, eventually replacing entire sections with the same section names already found in the .ini file.
July 12, 20214 yr Author 7 minutes ago, RXP said: Hi, Is this the one you're referring to?https://www.avsim.com/forums/topic/521970-official-panel-configuration-thread/?tab=comments#comment-3745349 My understanding is that the mod in this post only shows the sections which are relevant for displaying the gauges in the virtual cockpit, which you'll add to the existing RealityXP.GNS.ini file found in your C90 folder. If you don't have any yet, just load the aircraft and enable both the 530 unit1 and the 430 unit2, which are the ones this mod is using. Once done, you just need to copy/paste these into your RealityXP.GNS.ini file in the C90 aircraft folder, eventually replacing entire sections with the same section names already found in the .ini file. Yes, that's the one. I just made my own RealityXP.GNS.ini based on the file. I never realized enabling the 530 and 430 from the plugin created an .ini. I will remove the .ini I made, enable 530/430 from the plug in and then attach all the info per the instruction. I should add I have the Realsimgear as well but I don't think that will make a difference. Thanks for the help.
Archived
This topic is now archived and is closed to further replies.