Hello,

first of all, thank you for your LNM wonderful programm !

I'would report a (little) problem which occurs since 2.6.12 version : it concerns a bug when printing the table header of the flight plan.

I've done a look at the FAQ section but didn't found any relevant post.

The destination data, runways and some others are shown by their variable name (or position) instead of value.

Here are two screen shots to show the problem :

1) all OK under v 2-6-11 :

2) missing data with 2-6-12 and over

Hope it helps to solve the case.

Thank you again !

Alain

 

Try updating to 2.6.16 which has a number of these kinds of problems addressed -- see 

 

Hello pgde

thanks for your answer.

I've downloaded in time each updated version and unfortunately the problem is always here.

The bug occured with the 2.6.12 and persists until 2.6.16 included. No problem with the 2.6.11 (see the screen captures in my first post)

IMHO (I was an analyst/programmer) the missing datas seem to be refered to as positioning variables instead of named ones ?

So, I keep the 2.6.11 and 2.6.16 versions in separate places. As databases are in the same location, I create the flight plan under 2.6.16 and print it from the 2.6.11 !

 

Perhaps it'll be corrected in the next version.

 

Have good flights

It seems that the translation files have to be updated. You can switch LNM to English or use the translation files from an older LNM version (probably 2.6.11) which do not have this artifact. The files are ".../Little Navmap/translations/littlenavmap_fr.qm" and ".../Little Navmap/translations/atools_fr.qm"

Alex

 

Hello,

thank you for your answer : I copied the two translation files from the 2.6.11 towards the 2.6.16 and everything is ok now. (N.B. I've only tested french language.)

Perhaps a detail to think about for LNM next updates ?

Congrats again for your work !

 

Alain

 

Hi Alain,

glad that it is fixed. I'll contact the translators. Maybe I can get updated files to publish here.

Alex