hi guys

recently, i purchased a32nx fs2crew pack. 

seems working good but i had some issues

1. starting engine voice command won't work

- i saw some youtube videos where command ' starting engine 2(1)' make F/O start engine automatically, but in my case, F/O just says 'checked' and do nothing

2. even though i set flaps 1+F before take off, there's error message , 'flap error' on main pannel

3. i saw some other man posted below the forum, having same issue of mine, after flap1 when approaching, i tried to command 'flaps2' but F/O keep saying 'are you sure about that?' . for the record, I kept proper speed below 180 ~ 160. it won't work. 

 

except that i really had fun. please notice any solution. thanks.

Hi,

1. In an Airbus (based on OEM/stock Airbus procedures), Captain (that's you) start's the engines.  The FO doesn't do it for you.  You just announce what you're doing.  Other airplanes do it differently.

2. Make sure you set the Takeoff Flap in the MCDU on the PERF Page.

3. It sounds like FS2Crew is not reading data out of the aircraft for you.  Are you getting a WASM warning message?  This is probably also connected to #2.

 

replying 2. Make sure you set the Takeoff Flap in the MCDU on the PERF Page.

 

I did.. i tried to set flap   [1]/[ ], [1]/[up0], [1]/[dn1] everything ..but it keep showing >flaps error : POS0 detected<  ㅠㅠ 

 

 

oh, i figured it out finally !!

 

It was not development mode of a32nx .... It was stable mode...

after i reinstall development mode of a32nx it works !!

thanks !

4 hours ago, byork said:

oh, i figured it out finally !!

 

It was not development mode of a32nx .... It was stable mode...

after i reinstall development mode of a32nx it works !!

thanks !

 

 

7 hours ago, blueskyyk1 said:

 

Glad you sorted it 😉

Yes, you need to use the Development version of the FBW.

Cheers,