I have calibrated the yoke and pedals  though X-Pane 11 interface. 

I am finding in general the controls are too sensitive.

Can  anybody using these controls with X-Plane 11.55 give me any advice?  I am using the Just Flight PA-28R-181 Archer and trying to get it stable.  I am having what appears to be a trim issue as the A/C is having issues rotating at V1 with no back pressure on the yoke.

It seems to be an issue with calibration.  In MSFS 2020 /FSXSEI I don’t have these issues. 
 

Thanks!

 

Edited August 29, 20214 yr by Skyseek

What controls are you using to set the trim for take off and adjust during flight.

bob

Ok I am using the Go Flight LGT to set the trim.  
 

I did use the Yoke trim rocker switch and it worked, so ai think the problem is solved.  Just Flight acknowledged that they have no way to test the GF hardware.

I noticed that there is no takeoff mark/ settings on the trim wheel.  In real life, the trim stays at the last setting. is there away to gage where the trim setting is?

I played with some of the CH Products control settings in XPlane 11, but the control surfaces are still is pretty squirrely  I am hoping to make some adjustments.  
 

I did fly the stock Baron, and it was much smoother..

Any ideas?

 

Thanks!

6 hours ago, Skyseek said:

I noticed that there is no takeoff mark/ settings on the trim wheel.

The trim indicator should be between the seats.

regards bob