I'm looking to see if anyone else has experienced this issue in PBE.

Using the A320, Development version.  TCA sidestick and throttle quadrant. 

In PBE, I have "CRTL TUG SPEED (PUSH-PULL)" checked in the CFG.

Using voice control, the process is normal through the start of the pushback where the tug is moving the A320 backwards (PUSH), but after about 10 seconds the A320 slows, stops, and begins moving forward (PULL).  It would not stop moving forward and continued into the terminal. I tried it again after restart and the same result occurred and I had to kill the PBE pushback.

No joystick input or movement was used during the pushback, nor any buttons pressed.  This occurs before requesting engine start.  

I've tried this a number of times with the "CRTL TUG SPEED (PUSH-PULL)" in the CFG checked.  After unchecking it, the pushback was normal and worked as expected.

Let me know if anyone else is using this configuration and seeing this as well.

Steve

Sounds like a joystick calibration issue to me.

Is your joystick calibrated (properly centered).

Your joystick might be physically centered, but it could still be sending out a small forward elevator signal.