I'm trying to create a very simple route by entering Blackbushe EGLK RWY25 into FROM and Southampton EGHI RWY 20 into TO.

If I now try to enter Popham as an en-route waypoint by clicking on Popham and selecting ADD, I get a very weird routing.

Can somebody please try it and see if they also get unexpected results.

Click on the route line before adding a waypoint. Click the route line so that it's then highlighted, then add you waypoint and it will be put in between the two points on that line.

Thanks, just tried that it doesn't create a highlight just a custom waypoint on the line ?

23 minutes ago, GAJ52 said:

Thanks, just tried that it doesn't create a highlight just a custom waypoint on the line ?

Yes, that's been an issue since the previous update (for me at least). I had got used to clicking on the line and then creating a waypoint where I wanted it, but now it creates a waypoint on the line itself. The solution would be to enable you to drag the waypoints along the list near the top of the screen to re-order them. If Asobo could write that into the code, all would be well. As it stands, that list is... just a list. It could be so much more useful.

And yes, I tried your route just now and unsurprisingly got a daft route.

1 hour ago, 109Sqn said:

And yes, I tried your route just now and unsurprisingly got a daft route.

I thought it was just me doing something wrong as I rarely use the map, thanks for checking for me.

7 minutes ago, GAJ52 said:

I thought it was just me doing something wrong as I rarely use the map, thanks for checking for me.

No problem. Flew the route (without detour) since it was loaded. A bit concerned that somebody thought it appropriate for the designated areas for the likes of airstairs to be occupied like this. It would make for a nervous approach to your stand!