FS2Crew PMDG 737 NGXu no Powerup Procedure

[agutz 16]

PMDG 737 NGXu Panel state is cold and dark. FS2Crew config is:
FO Powerup proc:Yes
FO Prelim Proc: Yes
Preflight Sys Proc: Yes

After starting FS2Crew I see <Setup>, then <Prelim Preflight Proc>. No Powerup is taking place
At -22 FO is leaving for walk around.
Am I doing anything wrong?

[byork 2,260]

Hmmm, try re-installing the PMDG 737NGXu.

You want to ensure you're using a clean panel state file.

That's all I can suggest at this point.

Is the FO moving switches during the other stages of his flow?

[agutz 16]

I re-installed the the PMDG 737NGXu already, so the c&d panel state should be okay.
I'm using SOP1, by the way.
The FO is moving some switches before he leaves for the walk around. I didn't go on after that but I will try and see what happens.

[agutz 16]

It appears that FS2Crew is proceeding normally just without power-up.
737NGXu_Options.ini says:

[Panel State]
StartupPanelState=NGXU COLD DARK
[SDK]
EnableDataBroadcast=1

Would any other information be useful?

 

[byork 2,260]

On 1/14/2022 at 10:46 AM, agutz said:

PMDG 737 NGXu Panel state is cold and dark. FS2Crew config is:
FO Powerup proc:Yes
FO Prelim Proc: Yes
Preflight Sys Proc: Yes

After starting FS2Crew I see <Setup>, then <Prelim Preflight Proc>. No Powerup is taking place
At -22 FO is leaving for walk around.
Am I doing anything wrong?

Are you using SOP 3 by chance?

Because the FO will only power up the plane in SOP 1  or  2.

SOP 3 the user does most of the work.

[agutz 16]

As I said I'm using SOP 1

[byork 2,260]

7 minutes ago, agutz said:

As I said I'm using SOP 1

Sorry, I missed that.

What do you have "First Flight of the Day" set to?  

Make sure it's set to "Yes".

Also ensure the APU is off.

[agutz 16]

"First Flight of the Day" was Yes.
But "RUN ELEC PWR UP GPU PRE-CON" WAS NO, I set it to YES.
That did it: it's powering up now!
Thanks for your patience
 

[byork 2,260]

Excellent 🙂