PMDG 737 NGXu Panel state is cold and dark. FS2Crew config is:
FO Powerup proc:Yes
FO Prelim Proc: Yes
Preflight Sys Proc: Yes

After starting FS2Crew I see <Setup>, then <Prelim Preflight Proc>. No Powerup is taking place
At -22 FO is leaving for walk around.
Am I doing anything wrong?

Hmmm, try re-installing the PMDG 737NGXu.

You want to ensure you're using a clean panel state file.

That's all I can suggest at this point.

Is the FO moving switches during the other stages of his flow?

I re-installed the the PMDG 737NGXu already, so the c&d panel state should be okay.
I'm using SOP1, by the way.
The FO is moving some switches before he leaves for the walk around. I didn't go on after that but I will try and see what happens.

It appears that FS2Crew is proceeding normally just without power-up.
737NGXu_Options.ini says:

[Panel State]
StartupPanelState=NGXU COLD DARK
[SDK]
EnableDataBroadcast=1

Would any other information be useful?

 

On 1/14/2022 at 10:46 AM, agutz said:

PMDG 737 NGXu Panel state is cold and dark. FS2Crew config is:
FO Powerup proc:Yes
FO Prelim Proc: Yes
Preflight Sys Proc: Yes

After starting FS2Crew I see <Setup>, then <Prelim Preflight Proc>. No Powerup is taking place
At -22 FO is leaving for walk around.
Am I doing anything wrong?

Are you using SOP 3 by chance?

Because the FO will only power up the plane in SOP 1  or  2.

SOP 3 the user does most of the work.

As I said I'm using SOP 1

7 minutes ago, agutz said:

As I said I'm using SOP 1

Sorry, I missed that.

What do you have "First Flight of the Day" set to?  

Make sure it's set to "Yes".

Also ensure the APU is off.

"First Flight of the Day" was Yes.
But "RUN ELEC PWR UP GPU PRE-CON" WAS NO, I set it to YES.
That did it: it's powering up now!
Thanks for your patience
 

Excellent 🙂