I have saitek X-55 throttles with no detentes and I find it very hard to retard throttles to idle detent at 20 feet (I should stop like 20% of throttles back travel for idle detent position), is there a way to assign reversers to another axis and just leave throttles to be lowered all the way for idle detent?

53 minutes ago, penta_a said:

I have saitek X-55 throttles with no detentes and I find it very hard to retard throttles to idle detent at 20 feet (I should stop like 20% of throttles back travel for idle detent position), is there a way to assign reversers to another axis and just leave throttles to be lowered all the way for idle detent?

I set a switch on my Joystick to "Toggle reverse thrust". Hit that after touching down, you are in reverse thrust controlled by your throttle. Hit it again, and you come out of reverse for taxiing to the gate. 

Here's the setup I'm using:

I didn't calibrate my throttles in the Fenix MCDU.

I set Throttle cut to one of the buttons on the Honeycomb Airbus throttle levers.

Then I set decrease throttle 1 and throttle 2 in the 2 buttons where you pull down the throttles.

When you land, hit the Throttle cut button, and pull the throttles to reverse. Then you can raise the throttles out of reverse and control the reverse speed. To get out of reverse, click the throttle cut again.

 

many thanks gentlemen, I will try that buttons assignments.