Hello Dave, I may have discovered a new bug when exporting flight plans to/for MSFS.  With the latest beta I recently created a new flight plan and exported it to a specified folder on my PC drive so could later import it into MSFS.  Once in MSFS on the world map flight planning screen, I then proceeded to load my new flight plan.  I like to do this so that when I load into the flight itself, the flight plan is then automatically loaded into the plane's GPS.  

With this latest beta when the exported flight plan is loaded in the World Map screen, the boxes just under the "from" and "to'" airport selections (where you would designate your parking spot for example) are populated with "-AIRBORNE- xxFt" with no way to change them.  A message also briefly displays that says that no high airways exist for that route.  

The reason I believe it's a new bug in the flight plan export is that previously created flight plans load up fine.  As an extra test, I rolled back to an earlier version of P2A, created a new flight plan, loaded into MSFS, and the new flight plan created in the older version loaded just fine as well.  

I then re-installed the latest beta, created a new flight plan, went back into MSFS, and the newly created flight plan from the latest beta once again loaded with that funky "AIRBORNE" entry above.

Edited February 19, 20233 yr by mikeklimek

Mike,

Please email the broken and working flight plan .pln files to [email protected] so I can compare and figure out what is causing the problem.  

Thanks,

Dave

Mike,

Never mind.  I think I found the issue and will get a new beta out shortly.

Dave

Edit:  2.6.4.2 Beta 5i has the fix.

Edited February 19, 20233 yr by Dave-Pilot2ATC

Can confirm it works now with the latest beta.  Thanks Dave!